RAD Data comm IPmux-1 - Manual (Page 50)

Chapter 3 Operation IPmux-1/1E Installation and Operation Manual
3-4 Operating Instructions
Table 3-2. IPmux-1E (BRI/FXS) System Indicators and Switches (Cont.)
No. Name Type Function
4 ETH LINK LED On: Line OK
Off: Link not active
5 ETH ACT LED On: Frame being transferred on line
Off: No activity
6 ETH
100M
LED On: 100 Mbps
Off: 10 Mbps
7 ETH FDX LED On: Full duplex
Off: Half duplex
8 POWER Switch Turns IPmux-1E power ON and OFF
3.2 Operating Instructions
Turning IPmux-1/1E On
Without Control Terminal
The IPmux-1/1E power switch is located on the back panel, as shown in
Figure 3-2.
➤
To power up IPmux-1/1E without a Control terminal:
1. Turn the power supply switch, located on the rear panel, to ON.
2. Check the unit LED indicators, located on the left side of the front panel, and
the module indicators for proper operation (see Figure 3-1, Figure 3-2,
Figure 3-3, Figure 3-4, Table 3-1, and Table 3-2).
With Control Terminal
➤
To power up IPmux-1/1E with a Control terminal:
1. Make sure all IPmux-1/1E cables and connectors are properly connected.
2. Connect IPmux-1/1E to a PC equipped with an ASCII terminal-emulation
application (for example, Windows 95 Hyper Terminal or Procomm).
3. Turn on the control-terminal PC and set its default port parameters to
19,200 baud, 8 bits/character, 1 stop bit, No Parity. Set the terminal emulator
to ANSI VT100 emulation (for optimal view of system menus).
4. Switch ON the POWER supply switch, located on the rear panel.
5. When the initialization and self-test are over, a menu appears displaying
initialization and self-test results. If the self-test is successful, the RDY LED
(Figure 3-1 and Figure 3-3) on the left side of the front panel lights. If problems
are encountered, refer to Chapter 4 for instructions.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com