RAD Data comm IPmux-1 - Manual (Page 45)

IPmux-1/1E Installation and Operation Manual Chapter 2 Installation
Installation and Setup 2-9
Connecting the Power
To connect power to Ipmux-1/1E, refer to the appropriate section below,
depending on your version of the unit (AC or DC).
AC Power Connection
AC power is supplied to IPmux-1/1E through the 5-ft (1.5m) standard power cable
terminated by a standard 3-prong plug. The cable is supplied with the unit.
➤
To connect AC power to IPmux-1/1E:
1. Verify that the AC outlet is grounded properly. Ensure that the supply voltage is
in the range 100 VAC to 240 VAC.
2. Check that both Power switches on the rear panel are set to OFF.
3. Connect the power cable to the rear panel connector first and then to the
AC mains outlet.
DC Power Connection
A DC power supply option is available to be ordered for IPmux-1 only (not
available for IPmux-1E. For information about connecting the DC power supply
refer to the DC Power Supply Connection Supplement at the back of this manual.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com