RAD Data comm IPmux-1 - Manual (Page 81)

IPmux-1/1E Installation and Operation Manual Chapter 5 Application Configuration Procedures
Configuring the Management Option 5-15
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
AUTHENTICATION/COMMUNITY MENU
1. Authentication Failure Trap On
2. Trap Public
3. Read Public
4. Write Public
ESC> Exit
Select item from the menu:
Figure 5-8. Authentication/Community Menu
Verify that your Read and Write communities on the NMS match the ones on
IPmux-1/4.
Manager List
➤ To configure the Manager in IPmux-1/4:
1. From the Management Configuration menu, press 2 Manager List (see
Figure 5-9).
2. Enter the Manager IP Address (the Manager IP Address in Figure 5-9 is used
as an example. Choose the Manager IP Address of your application).
3. Select Status Change Trap according to your application requirements (for
details refer to Manager List in the IPmux-4 manual.
4. Select Alarm Trap according to your application requirements (for details refer
to Manager List in the IPmux-4 manual.
5. Select System Trap according to your application requirements (for details
refer to Manager List in the IPmux-4 manual.
6. Press <S> to save the configuration.
7. Press <Esc> a few times to return to the Main menu.
Remember to press <Enter> after modifying each parameter. Press <S> to save
all changes on the menu.
Main Menu
↓
2. Configuration
↓
1. General
Configuration
↓
3. Management
Configuration
↓
2. Manager List
Note
Note
Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com