Oki C 9400 - Manual (Page 136)

Notes
Any parts of the print image that go beyond the printable area as a result of this adjustment are
clipped.
Negative values are invalid in the PostScript mode.
DUPLEX Y ADJUST
Applies when using duplex printing (printing on both sides).
Shifts the print position of the entire page's image up or down relative to the top margin.
Settable in 0.25 millimeter increments.
Note: Any parts of the print image that go beyond the printable area as a result of this
adjustment are clipped.
TRAY1 NOBI PAPER
TRAY2 NOBI PAPER
TRAY3 NOBI PAPER
TRAY4 NOBI PAPER
TRAY5 NOBI PAPER
If you are using A3 NOBI, A3 WIDE, or TABLOID EXTRA paper, use this setting to tell the
printer which of the three sizes is loaded in the designated tray.
TRAY1 LEGAL 14 PAPER
TRAY2 LEGAL 14 PAPER
TRAY3 LEGAL 14 PAPER
TRAY4 LEGAL 14 PAPER
TRAY5 LEGAL 14 PAPER
Sets the length of the legal paper in the designated tray. Change this to LEGAL 13.5 if that is
the standard legal size in your country.
PCL TRAY2 ID#
PCL emulation only.
For use by programmers. When setting the paper feed destination command (ESC&l#H), the
number set here represents Tray 2.
PCL TRAY3 ID#
135