Oki C 9400 - Manual (Page 388)

3. Reattach the interface cable.
4. Plug the power cord into the power outlet and turn the printer on.
Step 4: Check for Proper Installation
Check the MenuMap printout to be sure that the DIMMs are properly installed:
1. On the printer control panel, press MENU once or twice until INFORMATION MENU
appears on the display.
2. Press SELECT.
PRINT MENU MAP
appears on the display.
3. Press SELECT.
The MenuMap prints.
4. Check the top of the MenuMap printout to verify that the DIMMs you installed are listed.
Note: If the DIMM is not listed at the top of the MenuMap printout, open the printer back up
and make sure the memory board is firmly in place, then print the MenuMap out again.
Step 5: Change the Memory Setting in the Drivers
Windows PostScript Driver
1. Click Start
→ Settings → Printers.
2. Right click the OKI C9200 or C9400 PostScript driver icon, then click Properties.
3. Select the added memory:
Windows 2000 and NT 4.0
a. Click the Device Settings tab.
b. Scroll down to Installable Options and click Memory Configuration.
c. Under Change 'Memory Configuration' Setting, click the total memory installed
(original plus memory you just installed).
Windows Me, 98 and 95
a. Click the Device Options tab.
b. Click Memory Configuration.
c. Under Change setting for: Memory Configuration, click the total memory installed
(original plus memory you just installed).
387