Oki C 9400 - Manual (Page 137)

PCL ® emulation only.
For use by programmers. When setting the paper feed destination command (ESC&l#H), the
number set here represents Tray 3.
PCL TRAY4 ID#
PCL emulation only.
For use by programmers. When setting the paper feed destination command (ESC&l#H), the
number set here represents Tray 4.
PCL TRAY5 ID#
PCL emulation only.
For use by programmers. When setting the paper feed destination command (ESC&l#H), the
number set here represents Tray 5.
PCL MP TRAY ID#
PCL emulation only.
For use by programmers. When setting the paper feed destination command (ESC&l#H), the
number set here represents the multi-Purpose Tray.
HEX DUMP
Go to this item in the menu and press the SELECT button to print the data received by the
printer in hexadecimal code.
To return to normal printing, turn the printer off, then on again.
System Configuration Menu
Sets system parameters.
Defaults are red bold print.
Item (see descriptions below) Values
POWER SAVE DELAY TIME 5 MIN, 15 MIN, 30 MIN, 60 MIN , 240 MIN
PERSONALITY AUTO EMULATION , PCL, Adobe PostScript
CONTROL-T ENABLE , DISABLE (PostScript only)
CLEARABLE WARNING ON , JOB (PCL only)
AUTO CONTINUE ON, OFF
136