Poor print quality – Tally Genicom Tally Colour Laser T8006e User Manual
Page 106
Tally T8006e Color Laser Printers User Guide
98
Poor Print Quality
Poor print quality may be due to various causes. Proceed to the following
problem-and-correction procedures.
Caution!
Do not disassemble the printer for further troubleshooting and/
or repair. If the problem is not found and corrected after following these
troubleshooting steps, contact a Tally Service Technician.
Poor Print Quality
Possible Cause
Correction
Characters and lines are
faint.
Graphics are partially
blank and/or have light
striping.
Characters and graphics
printed on labels or thick
paper peel off.
Characters and graphics
printed on plain paper are
too glossy.
Characters and graphics
printed on transparencies
are too light or dark when
projected.
The printer is set to print at
Standard or Draft Mode.
Set the printer to High-Quality
Mode.
The printer is set for Toner
Save.
Turn off the Toner Save
The Density Adjustment is set
too light.
Adjust the Density Adjust-
The wrong paper type is speci-
fied.
Specify the correct paper type.
The paper is incompatible for
printing.
Reload the paper tray with the
correct paper type.
The paper is too old and/or is
extremely dry.
Reload the paper tray with
fresh paper.
Multiple sheets of paper over-
lap while printing one sheet.
Make sure multiple pages are
not jammed within the printer.
The toner is depleted.
Replace the toner cartridge(s)
The OPC belt charging wire is
dirty.
Clean the charging wire