Setting the opc belt counter to zero – Tally Genicom Tally Colour Laser T8006e User Manual
Page 25
Chapter 2 Setting Up Your Printer
17
Setting the OPC Belt Counter to Zero
Printer software tracks OPC belt usage. After the counter reaches a pre-
set number, the printer displays a message to indicate that maintenance is
necessary. After the first installation, and after every replacement of the
OPC belt, set the counter to zero.
1. Take the printer off line, by
pressing the ONLINE key.
Press and hold the MENU/
ENTER/ . The printer shows
test mode, keep pressing the
menu key until printer says util-
ity menu. Release the MENU/
ENTER/ key and press it
once.
2. When Warming up is displayed
(about 5 seconds), release
MENU/ENTER/ . The dis-
play will show Utility Menu
Clear FC. Roll.
3. Press either TRAY/ or MEDIA/ until the display shows Clear
BeltCG.
4. Press MENU/ENTER/ . The display will show Clear BeltCG Not
Execute.
5. Press either TRAY/ or MEDIA/ until the display shows Clear
BeltCG Execute.
6. Press MENU/ENTER/ . The display will show
Clear BeltCG Exe-
cute.
7. Press MENU/ENTER/ . The display will show Completed Clear
BeltCG.
8. Press MENU/ENTER/ . The display will show Utility Menu
Clear BeltCG.
9. Press the key three times to exit the utility menu and then press the
ONLINE key. Or turn the printer off.
Note:
For information about displayed error messages, see “Appendix D Control