Tally Genicom Tally Colour Laser T8006e - Manual (Page 121)

113
Appendix B
Periodic Replacement
Parts
Some of the component parts of the printer naturally deteriorate over
time. Periodic replacement of these parts will ensure the highest quality
output from your printer.
The following table gives suggested intervals for replacing these parts.
Because the life span of periodic replacement parts depends on how the
part was used, it may have to be replaced earlier than the time indicated
below. If you use a periodic replacement part beyond its specified life
span, printing quality may be reduced and errors or paper jams may occur.
A service engineer should replace these parts. Contact your dealer or
authorized Tally service representative.
Note : After high-volume printing conditions, the control panel may begin
to display messages indicating that certain printer parts are worn and need to
be replaced (refer to “Appendix D Control Panel Messages” on page 147 for
more information). These parts should only be replaced by a qualified service
technician or a Tally service engineer.
Periodic Replacement Parts Replace When Part Location
Feeder Roller About 120,000 pages are
printed
Printer and
paper feeder
Separation Pad About 120,000 pages are
printed
Printer and
paper feeder
Paper Discharger About 120,000 pages are
printed
Printer