Trimble Outdoors 5700/5800 - Manual (Page 122)

13 Setting up the Receiver
1 10 5700/5800 GPS Receiver User Guide
5800 GPS Receiver Oper
ation
• When disconnecting a Lemo cable, grasp the cable by the sliding
collar or lanyard and pull the cable connector straight out of the
port. Do not twist the connector or pull on the cable itself.
• To securely connect a TNC cable, align the cable connector with
the receiver receptacle, then thread the cable connector onto the
receptacle until it is snug.
• To insert the internal battery place the battery in the battery
compartment, ensuring that the contact points are in the correct
position to align with the contacts in the receiver. Slide the
battery and compartment as a unit upward into the receiver
until the battery compartment latches are locked into position.
13.3
Pole-Mounted Setup
Figure shows the pole-mounted setup for the 5800 receiver. To mount
the 5800 receiver on a range pole:
1. Thread the unit onto the range pole
2. Attach the controller bracket to the pole
3. Insert the controller into the bracket.
With the Trimble ACU, or TSCe controller with Blue
Cap module,
no cabling is required, as shown in Figure 13.3.