Trimble Outdoors 5700/5800 - Manual (Page 66)

5 Configuration
5 4 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Oper
ation
For more information on the default receiver settings, see Default
Settings, page 78.
Although you cannot change or delete the default application file, you
can use a power up application file to override any or all of the default
settings.
Current application file
The current application file (Current.cfg) reflects the current receiver
configuration. Whenever you change the receiver’s configuration,
either in real time or by applying an application file, the current file
changes to match the new configuration.
You cannot delete the current file or change it directly, but every
change to the receiver’s current configuration is applied to the current
file as well.
When you switch off the receiver then turn it on again, all the settings
from the current application file are applied, so you do not lose any
changes that you have made. The only exceptions are the following
logging parameters:
• Logging rate
• Position rate
• Elevation mask
These parameters are always reset to the factory default values
whenever the receiver is switched off.
Power Up application file
The power up application file (Power_up.cfg) is optional. If a power up
file is present, its settings are applied whenever the receiver is powered
up.