Special application files, 5700 gps receiver oper ation – Trimble Outdoors 5700/5800 User Manual
Page 65
5700/5800 GPS Receiver User Guide 53
Configuration 5
5700 GPS Receiver Oper
ation
•
Serial Port Baud/Format
•
Reference Position
•
Logging Rate
•
SV Enable/Disable
•
Output Message
•
Antenna
•
Device Control
•
Static/Kinematic
•
Input Message
•
Timed Activation
An application file does not have to contain all of these records. When
you apply an application file, any option that is not included in the
records in the file remains at its current setting. For example, if you
apply an application file that only specifies the elevation mask to use,
all other settings remain as they were before the application file was
applied.
You can store up to twenty different application files in battery-backed
memory on the receiver. You can apply an application file’s settings at
the time it is transferred to the receiver, or at any time afterwards.
54.1
Special application files
The 5700 receiver has three special application files, which control
important aspects of the receiver’s configuration.
Default application file
The default application file (Default.cfg) contains the original receiver
configuration, and cannot be changed. This file configures the receiver
after it is reset. You can reset the receiver by holding down
[P]
for at least
15 seconds, or by using the reset option in the GPS Configurator
software.