Trimble Outdoors 5700/5800 - Manual (Page 92)

9 Default Settings
8 0 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Oper
ation
9.2
Resetting to Factory Defaults
To reset the 5700 receiver to its factory defaults, do one of the following:
• Press and hold down [P] on the 5700 receiver for 15 seconds.
•
In GPS Configurator, select the General tab and then click
Reset Receiver .
9.3
Examples
The following examples show how the 5700 receiver uses the default
settings and special application files in various situations.
93.1
Default behavior
The factory defaults are applied whenever you start the receiver. If a
Power Up file is present in the receiver, its settings are applied
immediately after the default settings, so you can use a Power Up file to
define your own set of defaults.
When you turn the receiver on
and … then logging settings
are … and logging …
it is the first time that the receiver has
been used the factory defaults does not begin
automatically
you have reset the receiver to its factory
defaults the factory defaults, or those
in the Power Up file
a
a A factory default setting is only used if the setting is not defined in the Power Up file.
does not begin
automatically
you have performed a full reset the factory defaults, because
resetting deletes any Power
Up file does not begin
automatically