Trimble Outdoors 5700/5800 - Manual (Page 94)

9 Default Settings
8 2 5700/5800 GPS Receiver User Guide
5700 GPS Receiver Oper
ation
However, when you switch off the receiver using [P] , the receiver
behaves as if you pressed [D] to stop logging before you pressed [P] . In
this case, when power is restored normally, logging does not begin until
you start it manually.
93.4
Disabling logging
You can disable logging by setting the receiver’s data logging and
position logging rates to Off. However, if you press
[D] while logging is
disabled, the receiver will still log data, using the default logging
settings.
93.5
Application files
You can use application files to change the settings in the receiver.
Sending an application file to the receiver does not necessarily apply
the file’s settings; you can apply a file’s settings at any time after sending
it to the receiver. You can also define timed application files. A timed
application file contains receiver settings, but also includes a date and
time when it is automatically activated.
When the receiver is logging
data and then loses power … then when
power is
restored, data
logging … and logging
settings are … and all other
settings are …
unexpectedly resumes
automatically the last settings
used the last settings
used
when you press [P] does not resume the factory
defaults the last settings
used
When you have disabled logging … then if you press [D] to start logging,
logging settings are …
using the Trimble Survey Controller or GPS
Configurator software the factory defaults
in the Power Up application file the factory defaults