Configuring the internal 900 mhz radio setup, 5700 gps receiver oper ation – Trimble Outdoors 5700/5800 User Manual
Page 83
5700/5800 GPS Receiver User Guide 71
Software Utilities 7
5700 GPS Receiver Oper
ation
9.
Once you configure all the frequencies you require, click
OK
.
The WinFlash software updates the 5700 receiver’s radio
frequencies and then restarts the receiver.
70.1
Configuring the internal 900 MHz radio setup
To configure the internal 900 MHz radio, use one of the following:
•
The Trimble Survey Controller software running on a Trimble
controller
•
The WinFlash software (provided on the Trimble R7, Trimble R8,
5700, and 5800 GPS Receivers CD)
The internal radio has 40 selectable networks. You must choose the
same network that is configured in the base radio you want to receive
from.
Configuring the radio network using the Trimble
Survey Controller software
1.
Connect the data/power cable to the controller and the receiver
and turn on the controller. The receiver starts automatically.
2.
From the main menu on the controller, select Configuration.
3.
In the dialog that appears, select Survey styles, then from the
Type field, select RTK.
4.
Select Rover radio, then from the Type field select Trimble
Internal.
5.
Tap the Connect softkey.
6.
Once connected, in the Network number field enter the number
of the network set on your base radio.
Note – The Base Radio Mode field is not used here.
7.
Tap the Enter softkey to complete configuration.