Trimble Outdoors 5700/5800 - Manual (Page 131)

5700/5800 GPS Receiver User Guide 1 19
General Operation 1 4
5800 GPS Receiver Oper
ation
Table 14.2 shows approximate storage requirements for different
logging rates. The values shown are for a one-hour logging session with
six satellites visible.
144.2
Logging to a Trimble controller
When the 5800 receiver is connected to a Trimble controller, you can
log GPS data from the receiver to the controller, or to a PC card inserted
in the controller. When you use a Trimble controller, you do not use the
receiver’s controls. Instead, you use the controller functions to set
logging options, specify filenames, and control when logging occurs.
Data is stored in job files, which can be transferred to your office
computer using Trimble’s Data Transfer utility.
For more information on logging data from a receiver using a Trimble
controller refer to the user guide for your particular controller.
14.5
Resetting to Defaults
To reset the 5800 receiver to its factory default settings, hold down [P]
for at least 15 seconds.
For more information, see Chapter 18, Default Settings.
Table 14.2 Storage requirements
Logging rate Memory required
10 Hz 2,588 KB
1 Hz 335 KB
5 seconds 87 KB
15 seconds 37 KB