Default settings, 5800 gps receiver oper ation – Trimble Outdoors 5700/5800 User Manual
Page 156
18 Default Settings
1 44 5700/5800 GPS Receiver User Guide
5800 GPS Receiver Oper
ation
All 5800 receiver settings are stored in application files. The default
application file, Default.cfg, is stored permanently in the receiver, and
contains the factory default settings for the 5800 receiver. Whenever
the receiver is reset to its factory defaults, the current settings (stored in
the current application file, Current.cfg) are reset to the values in the
default application file.
You cannot modify the default application file. However, if there is a
power up application file (Power_Up.cfg) in the receiver, the settings in
this file can be applied immediately after the default application file,
overriding the factory defaults.
For more information, see Application Files, page 125.
18.1
Default Settings
Table 18.1 defines the default settings for the 5700 receiver, as defined
in the default application file.
Table 18.1
Default settings
Function
Factory default
SV Enable
All SVs enabled
General Controls:
Elevation mask
13°
SNR mask
7
RTK positioning mode
Low Latency
Motion
Kinematic
Serial Port 1:
Baud rate
115,200
Format
8-None-1
Flow control
None
Serial Port 2:
Baud rate
115,200
Format
8-None-1
Flow control
None