Uniden UBCD996T - Manual (Page 122)

122
Q g
Q g
Q g
Q g
Input how far away the alert sounds for the site (only
available for POI’s)
The Alert Tone is fixed.
select from 15 sound levels, plus Auto and Off. As
you rotate the the Alert tone is played louder and louder. Press to
select a volume level. You can also select no sound (Off) or Auto, a level that is the
same setting as your master volume control setting.
For Dangerous Xing and Dangerous Road sites there are two additional settings:
You can input the compass direction to the site from
your present location or, you can select All Range.
For example: If the location is toward the Northeast and you are
driving in that direction, then choose
If you know you will be driving a course which is not a fairly straight line to that site,
choose which will trigger the alert regardless of direction as long as the
other requirements (range, speed) are met.
If you travel in a Northeast direction and do not travel either side of a northeast line
by up to 22 degrees, the alert system will function.
Choose from 0, through 100 MPH in 5 PHM steps or
the equivalent in KPH for metric usage.
If you press , the scanner switches to a GPS display mode. In this mode, you
can see location information as well as information about your position relative to the
selected POI. The third line of the screen shows if no POI is selected.
Rotate the to select different POI’s.
Press ( ) + to toggle the Display mode in order.
Set Range
Set Alert Volume
Set Heading
NE (45°)
All Range
Set Speed Limit
Off
For Dangerous Xing, and Dangerous Road Only
Scroll Control
Dangerous Road
[GPS]
Scroll Control
[GPS]
GPS Display Mode