Uniden UBCD996T User Manual
Page 89
89
Auto
Auto
AM
FM
NFM
WFM
WFM
Auto
Program System
Edit Group
Edit Channel
Set Attenuator
On
Off
Off
Program System
Edit Group
Edit Channel
Set Priority
— the scanner uses the default modulation for the channel. The default setting
is
.
— the scanner uses AM (amplitude modulation) for the channel.
— the scanner uses FM (frequency modulation) for the channel.
— the scanner uses narrowband FM for the channel.
— the scanner uses wideband FM for the channel.
(Broadcast)
the scanner uses FM Broadcast for the channel.
This setting controls the modulation method used for the channel. In most cases, if
you leave this set to
, the scanner automatically selects the correct modulation
type for the channel you are programming.
Select a conventional system
(existing site)
Select a channel group
Select a channel
This setting controls whether the scanner attenuates signals on this channel. Select
your setting, then press .
— the channel is attenuated by about 20 dB.
— the channel is not attenuated. The default setting is
.
You can also toggle this setting by holding on the channel and pressing
then
within 2 seconds.
Select a conventional system
Select a channel group
Select the channel
—
[MENU]
[7]
[MENU]
Setting Channel Attenuation
C
g
g
Q
g
Q
g
Q
g
Q
g
Q
g
Q
g
g
g
Q
g
Q
g
Q
g
Q
g
Q
g
Q
g
Setting Channel Priority
C