Uniden UBCD996T - Manual (Page 34)

Important: AVOID AIRBAG DEPLOYMENT ZONES. Ignoring this installation
concern may result in bodily harm and the inability of the airbag to perform properly.
1. Using appropriate screws or other hardware, secure the bracket.
2. Insert the scanner and insert the bracket knobs to lock the scanner in position.
3. Attach the Cigarette Lighter Power Cord to the rear of the scanner and plug the
adapter end into a dash mounted 12V DC socket.
4. Attach a suitable mounted mobile antenna to the antenna jack on the back of the
scanner.
If you are unsure about how to install your scanner in your vehicle using the DIN-E
sleeve, consult your automobile manufacturer, dealer, or a qualified installer. Before
installing, confirm that your scanner fits in the desired mounting area and you have
all the necessary materials to complete the task. Your scanner requires a 2-1/8 x 7-
1/5 x 5-5/16 inch (53 x 183 x 135 mm) mounting area. Allow an additional 2-3/8 inch
(60 mm) space behind the unit for connectors and wires.
Mounting Using the DIN-E Sleeve
34
UBCD996T