Uniden UBCD996T User Manual
Page 82
On
Off
On
Program System
Edit Site (current)
Set LocationInfo
Set Latitude
Set Longitude
Set Range
Set GPS Enable
Program System
Edit Site (current)
Adjust P25 Level
Auto
— You only need to enter control channel frequencies.
— You must enter all voice and control channel frequencies.
The scanner defaults to
.
Select a trunked system
Select a site
This setting control whether the system is automatically enabled and disabled when
you connect a GPS to the scanner.
— Enter the system’s latitude using the format you selected in the
system settings.
— Enter the system’s longitude using the format you selected in
the system settings.
— Set the system’s range using the units you selected in the system
settings.
— Depending on the data received from the GPS, the L/O status
of the site is automatically controlled.
Select a trunked system
Select a site
This setting determines some site-specific parameters for digital channels. In most
cases, setting this to
provides the best performance. However, you can also
manually set the digital decode threshold. This setting affects all channels in the
current site. See “ Optimizing P25 Performance” on Page52.
Note:
[MENU]
[MENU]
Setting Site Location Information
MESL
Adjust P25 Level
MEL
Q
Q
Q
Q
g
g
Q
g
Q
g
Q
g
Q
g
g
g
g
g
g
g
82