Uniden UBCD996T - Manual (Page 60)

60
2. While pressing , , and at the same time, turn on power.
At that point anything you have programmed is gone.
You are given a last opportunity to keep the factory programmed data when you see
the question:
You can connect your scanner, by means of the
supplied cable, to a personal computer to
download data from the computer to the memory of
the scanner. Before you proceed, you must first set
the scanner’s communications speed as described
in the previous section. In addition you will need a
copy of Uniden Advanced Scanner Director
software. You can download the software from
in the Customer Service
Downloads link.
Start with a high baud rate setting. If, during transfer, you get an error
message, reduce the setting and start again until you get reliable, complete transfer
of data.
If you use a PC to control the scanner, and you change the scanner’s volume or
squelch setting using the PC, the scanner ignores the front-panel control’s current
setting. However, if you later change the volume or squelch setting using the front-
panel control, the scanner uses the control’s setting (i.e. the scanner pays attention
to the last method used).
Using the scanner in a cloning setup lets you transfer programmed data directly from
a or UBCD996T to a or UBCD996T. Wired cloning
between other models to the UBCD996T is not possible.
or (select one as the master
and one as the slave)
[2] [9] [HOLD]
If you do not say Yes, the scanner is totally empty.
Important:
master slave
[MENU]
Restore Preprogram List? Yes=”E”/”No= ”.”
Wired Clone Master Slave
Connecting Your Scanner to a Personal Computer
Wired Cloning
www.uniden.com.au
source target
Volume/Squelch with PC Control