Uniden UBCD996T - Manual (Page 99)

99
Trunked Search and Store
You can store talk group ID’s into the system you selected in “Selecting a System”.
Otherwise, the scanner stores talk group ID’s in a new group it creates.
Trunked system search and store does not work if an EDACS SCAT system is
selected, a system with no frequency is selected, the quick key to which the system
belongs is turned off, and the group you selected to store found talk group ID’s
contains more talk group ID’s than the maximum set in Max Auto Store.
To store a trunked system, follow the beginning steps in Selecting A System above.
When you select a Trunked System and press , the scanner enters TGID Search
and Store mode.
When you select a trunked system, the scanner looks for active talk group ID’s
within that range and appears and scrolls across the
display’s lower line while the system/site name appears on the display’s upper line.
When the scanner finds an active talk group ID, it checks if the talk group ID has
already been stored in the site. If it has, the scanner continues to search. If the talk
group ID has not been stored, it stores the talk group ID into a group named
, then resumes searching. The scanner creates this group if it does not
already exist.
Note:
ID SEARCH AND STORE
Found
Channels