Uniden UBCD996T - Manual (Page 72)

Setting the Status Bit M
Setting End Code Operation M
Setting I-Call Operation ME
[MENU]
Note:
[MENU]
Note:
[MENU]
Select a Motorola Type I or II system
— the scanner rounds all received ID’s down to the next interval of 16. The
default setting is .
— the scanner treats all received ID’s as unique ID’s.
Motorola analog systems use talk group ID’s in multiples of 16. ID numbers
that fall between these ID’s indicate special status flags for the system. This setting
determines how the scanner will handle ID’s that are not multiples of 16.
Select your setting then press .
Select a Motorola Type I or II system
This setting determines how the scanner handles the transmission end code sent by
most Motorola systems. Select your setting then press .
— the scanner immediately returns to the control channel when it detects the
end code.
— the scanner does not return to the control channel until the carrier drops.
The default setting is .
Select a Motorola Type I, II or EDACS Wide/Narrow system
This setting determines how your scanner treats I-calls while ID Searching.
— the scanner tracks I-calls.
Program System
Edit Sys Option
Set Status Bit
Ignore
Ignore
Yes
Program System
Edit Sys Option
Set End Code
Yes
Ignore
Yes
Program System
Edit Sys Option
Set I-Call
On
72