Uniden UBCD996T - Manual (Page 79)

79
Note:
[MENU]
Note:
+ [7]
[MENU]
[MENU]
If you select Control Channel Only mode (see “Setting Control-Channel Only
(Motorola Systems Only)” on Page 81), you only need to enter the frequency(s) that
can be assigned as the control channel. Most frequency lists usually indicate which
of the frequencies are the control channel frequencies. Otherwise, you must enter all
of the frequencies.
Select a trunked system
Select a Site
— the scanner uses the default modulation for the frequency band.
— the scanner uses FM (frequency modulation) for the frequency band.
— the scanner uses narrowband FM for the frequency band.
The default setting is .
This setting controls the modulation method used for the frequency band. In most
cases, if you leave this set to , the scanner automatically selects the correct
modulation type for the system you are programming.
Enable Attenuation if you are near strong signal sources. Attenuation can help
reduce interference and desensitization that strong signals create. You can also turn
this setting on or off by holding on a trunked system, then pressing .
Select a trunked system
Select a Site
— the attenuator is off.
— site frequencies are attenuated by about 20 dB.
Select a trunked system
Setting Site Modulation ML
Setting Site Attenuation MESL
Setting Site Lockout MESL
Program System
Edit Site
Set Modulation
Auto
FM
NFM
Auto
Auto
Program System
Edit Site
Set Attenuator
Off
On
Program System