Uniden UBCD996T - Manual (Page 70)

70
Setting the System Hold Time C
Setting ID Scan/ID Search MEL
Setting Channel Delay Time MELCS
Setting Data Skip C
[MENU]
[MENU]
[MENU]
[1] [5]
Notes:
[MENU]
Select a conventional system
Set how long the scanner will remain scanning on this system before moving to the
next system (up to 255 seconds). Note that the scanner will scan all unlocked
channels at least one time, regardless of the system hold time setting.
Select a system
Sets whether the scanner only stops on talk groups you have programmed in (ID
Scan) or whether the scanner stops on any unlocked channel (ID Search).
Select a system
This setting controls how many seconds the scanner waits after a transmission ends
before resuming scanning. Enter a value from to or , then press .
The default setting is 2 seconds for each system.
This setting applies to all channels within the system.
Select a Conventional system
This setting controls whether the scanner automatically skips channels it identifies
as data. This includes channels with either no audio or a constant-level audio
source. If turned on, the scanner resumes scanning as soon as it detects the data
signal.
Program System
Edit Sys Option
Set Hold Time
Program System
Edit Sys Option
ID Scan/Search
Program System
Edit Sys Option
Set Delay Time
Off
Program System
Edit Sys Option
Set Data Skip
!