Zebra Technologies TTP 7030 - Manual (Page 103)

103 Maintenance
Fitting A Shutter
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Fitting A Shutter
Figure 23 • Fitting a Shutter
The shutter kit contains a shutter and two hub-screws. In addition to this, you need an 1.5 mm
Allen-key.
1.
Fit one hub screw.
2.
Hook the shutter onto the screw and insert the other screw, through the hole in the shutter
and into the thread in the printer.
3. Make sure the head of the screw goes into the hole of the shutter and then tighten it.
4.
Verify that the shutter opens/closes as it should by printing a couple of documents.
Standard
printer
Allen screw/hub (2x)
Printer with
retract
Shutter