Zebra Technologies TTP 7030 - Manual (Page 97)

97 Interface
Serial Option, TTP 7030
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Serial Option, TTP 7030
The printer has a 10-pin connector on the control board. This connector can be used to connect
to an external RS-232 adapter. See
Connecting To The Computer on page 16 for installation
instructions.
The transfer speed of the serial interface can be set to between 2 400 and 115 200 bits/s.
This low transfer speed limits the printing speed. Printing full-width graphics with 115 200
bits/s result in printing speeds of about 24 mm/s for the 80-mm version of the printer, and
16 mm/s for the 112-mm version.
Applications where text-only printouts are to be printed are suitable for serial interface
because of its easy to use bi-directional capability.
Setup Options
See also: Default Parameter Settings on page 69 .
Table 5 • Serial Connector Pin Assignment
Printer 2 (RXD) 3 (TXD) 4 (DTR) 5 (GND) 6 (DSR) 7 (RTS) 8 (CTS)
PC (9 pole D-sub) 3 (TXD) 2 (RXD) 6 (DSR) 5 (GND) 4 (DTR) 8 (CTS) 7 (RTS)
Baud
2 400, 4 800, 9 600, 19 200, 38 400, 57 600, 115 200 bits/s
Flow control
None, Xon / Xoff, or Hardware
Data bits
7/8
Stop bits
1 (fixed)
Parity
None, Odd, or Even
Default settings:
9600 bits/s, 8-bits, No parity, 1 stop bit, and hardware flow control.