Zebra Technologies TTP 7030 User Manual
Page 44
Programming
Barcode Commands
44
P1003636-002
TTP 7030™ Technical Manual
10/05/2009
This command positions and prints a PDF 417 2D barcode.
<ESC> "|" <type=5> <x_msb> <x_lsb> <y_msb> <y_lsb> <rows> <cols> <errLevel>
<dotHeight> <scale> <len_msb> <len_lsb> <data>
ESC
|
n1
nx
Barcode Print (PDF 417)*
*. PDF 417 requires special firmware in the printer. See “Firmware” on page
1B
7C
n1
nx
Hex
027
124
n1
nx
Decimal
n1
Specifies the type of bar code. The following types are supported:
n1 = 5
PDF417
n2n3
<x_msb> <x_lsb> Sets the X-coordinate of the bar code field origin.
n4n5
<y_msb> <y_lsb> Sets the Y-coordinate of the bar code field origin. The
Y-coordinate are discarded in variable document mode.
n6
Rows
Columns
n7
n8
Error level, 0=auto, 1=Level0, 2=Level1, etc.
n9
Dot Height, sets mow many pixel lines each row consists of.
n10
Scale
n11n12
Len. If set to 00h, <nul> indicates the end of the data block <data>. If
<len is set to other values the value indicates the no of bytes in <data>
<data>
data to be encoded
Example •
To print Zebra as a PDF 417 barcode, send the following to the printer:
<ESC><124><005><000><000><000><000><000><000><000><003><003><000><
000>Zebra<000>
The barcode will look like this:
If <rows>, <cols> are 0 the printer will automatically set appropriate
values.