Zebra Technologies TTP 7030 - Manual (Page 76)

Default Parameter Settings
Print Setup 76
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Print Setup
A long burn time gives darker print. On insensitive paper types you may have to increase the
burn time to get an acceptable print quality.
The main reason to decrease the print speed is to enhance print quality, and to reduce the peak
current consumption.
Limits the maximum loop length. When the set length is reached, the printer ejects part of the
printout and continues too print. You use this when you have very limited space for the loop
inside the kiosk. Each step represents a 3.2-cm increment.
Setting the parameter to 0 disables the looping and feeds the paper straight out.
7
5 Default
Burn Time DRV 1 Min
15 Max
Note • DRV indicates that, when using Windows, the driver takes over this setting so please
set appropriate value in the driver properties/document defaults.
8
17 Default
Max Print Speed
1
DRV 1 Min
17 Max
n
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
mm/s
21 27 32 37 41 45 48 52 55 57 60 63 66 68 71 73 75
Note •
Some settings result in printer chassis resonance causing excessive noise and
deteriorated print quality. If this happens, increase the print speed.
9
15 Default
Presenter Loop Length 3 Min
255 Max
<ESC>&P<9><0>
Disable the loop
<ESC>&P<9><7>
16 cm loop
<ESC>&P<9><15>
48 cm loop