Zebra Technologies TTP 7030 - Manual (Page 117)

117 Specifications
Part Number List
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Figure 27 • Retract and Retain Version
Choose between four modes in the default parameter setup:
1.
Retract when new printout is printed.
2.
Retract after a preset time.
3.
Eject to customer when new printout is printed (wastebasket off).
4.
Eject to customer when new printout is printed, but retract if not collected within a preset
time.
No additional commands are required.
Note • Use paper rolls with an inner diameter of 40 mm or more when using the "retract and
retain" option to prevent the curl in the paper causing a jam in the retract function.
38
Exit to
wastebasket
Receipt exit
on same height
as normal printer 36
.5
SW00009
All measurements are in mm