Zebra Technologies TTP 7030 - Manual (Page 34)

Programming
Text Commands 34
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Text Commands
Text received by the printer is printed with the currently selected font and font attributes. Text
exceeding the page width is wrapped with the line spacing selected.
Changes the orientation of text and logotypes.
Portrait and landscape can be mixed on the same printout. There are two cursors, one for
portrait and one for landscape. The cursor always starts at the top left corner of the document.
Looking at the paper when it exits the printer, the portrait cursor is at the top left corner of the
printout, moving to the right as text is typed, while the landscape cursor is at the top right
corner, moving downwards.
Changes the alignment of text and logotypes.
ESC o n1
Text and Logotype Orientation
1B 6F n1 hex
27 111 n1 decimal
n = 0 Gives portrait orientation
n = 1 Gives landscape orientation
Note •
Landscape orientation can only be used with fixed document mode.
ESC N n1
Align Text
1B 4E n1 hex
27 78 n1 decimal
ESC N 0
= Left
ESC N 1
= Center
ESC N 2
= Right