Zebra Technologies TTP 7030 - Manual (Page 48)

Programming
Print Commands 48
P1003636-002 TTP 7030™ Technical Manual 10/05/2009
Print Commands
This command makes the printer print the contents of the line buffer. 
Text is converted from text to pixel lines and stored in the line buffer when an LF is received.
If the line buffer is empty when <ESC>p is received, nothing is printed.
Text to be printed <LF><ESC>p
prints "Text to be printed" on the paper.
Printout is effected automatically at:
This command makes the printer generate a self-test page based on the current parameter
settings and print that page. The parameter values printed are the ones currently being used.
They can differ from Power-ON default values if for example a printout from Windows has
been done before <ESC>P is sent to the printer. To make a self test printout with the Power-
ON default settings, power up the printer with the Feed button pressed.
The value n represents the number of dot lines the paper is to be transported forwards. Range:
1–255.
A dot line is 0.125 mm, and 255 dot lines equal approximately 32 mm.
ESC p
Print
1B 70 Hex
27 112 Decimal
Cut
<S
> and <ESC><RS>
Form feed <FF>
Clear presenter <ENQ>
Run presenter <ESC><FF><n>
Print buffer full
Press on FF-button
ESC P n1
Print Self-test Printout
1B 50 n1 Hex
27 80 n1 decimal
n = 0 Gives standard self-test printout.
n = 1 Gives a character set printout using the font selected by parameter p14.
ESC J n1
Paper Advance*
*. DO NOT use ESC J n, ESC j n, or ESC Q n in fixed page mode
1B 4A n1 hex
27 74 n1 decimal