Zebra Technologies TTP 7030 - Manual (Page 81)

81 Default Parameter Settings
Print Setup
10/05/2009 TTP 7030™ Technical Manual P1003636-002
Specifies the length of the black mark in 0.125-mm steps. Measure the length of the black
mark on your paper and enter that value here.
Marks 5 mm longer than this value are interpreted as paper out. The default value of 80 equals
10 mm.
This parameter specifies the minimum length of the black mark in 0.125 mm increments.
Shorter marks are ignored. The default value of 24 equals 3 mm. This filters out pre-print or
marks on the paper. If the mark is smaller than the value set for this parameter, it will not be
regarded as a TOF black mark. A value equal to 1/3 the length of a TOF black mark is usually
the most effective.
Defines the paper feed between the black mark detection and cut. One step is 0.125 mm.
Defines the distance between the top of the paper and the top of the first text line in 0.125 mm
steps. The top margin feed is effectuated when the presenter is cleared from the previous page.
Avoid settings 1 – 16 mm because then the printer must reverse the paper before starting to
print, which may cause paper jam, especially at small roll diameters.
39
80 Default
BM (Black Mark) Length DRV 16 Min
160 Max
<ESC>&P<39><40>
Sets max black mark length to 5 mm.
40
24 Default
Min BM (Black Mark) Length “Mark Filter” DRV 15 Min
159 Max
<ESC>&P<40><36>
Sets min black mark length to 4 mm.
41 & 42
0 , 0 Default
BM (Black Mark) Cut Offset DRV 0 , 0 Min
255 , 255 Max
<ESC>&P<41><1><ESC>&P<42><144>
Feeds 50 mm between black mark and
cut.
43 & 44
0 , 0 Default
Top Margin 0 , 0 Min
255 , 255 Max
0 = disabled top margin. This gives the physical top margin of the printer,
which is 17 mm.
<ESC>&P<43><0><ESC>&P<44><240>
Add 30-mm top margin.