Yamaha DME - Manual (Page 133)

Chapter 3 Main Panel Window
DME Designer Owner’s Manual 133
Remote Control Setup List
When you click the [Remote Control Setup List] command on the [Tools] menu, the “Remote Control
Setup List” dialog box is displayed.
Registers the parameters to be controlled from an external controller.
Names and Functions
[DME]
From the list, select the DME where you will be making settings.
[Function]
Select [No Assign], [Parameter Value Edit] or [Level Meter].
[Parameter]
Specifies the parameter to be controlled. A list of parameters will be displayed according to the
selection of [Function].
NOTE
DME Satellite units allow remote control via the [NETWORK] connector as well as via the [REMOTE] connector. The port to
be used is specified via the “Misc” tab of the “Utility” dialog box
(page 161) .
NOTE
For details about the communication protocol, refer to the “DME Remote Control Protocol Specifications” on the Yamaha Pro
Audio website (URL below).
http://www.yamahaproaudio.com/
NOTE
Does not apply to SP2060 units.
NOTE
Components for user modules are also listed in a hierarchal display, but if user module security is enabled, the
components are not displayed. However, parameters displayed in the user module editor are displayed here.