Yamaha DME - Manual (Page 430)

Chapter 6 Component Guide
DME Designer Owner’s Manual 430
Output Channel Switching
[Matrix Mixer - All Inputs to One Output] editor window displays the output channel clicked in the
matrix mixer component editor. The [Channel] buttons in the [Output] section of the [Matrix Mixer -
All Inputs to One Output] editor window switch the channel group that is displayed in the window.
If you make the matrix mixer component editor active while the [Matrix Mixer - All Inputs to One
Output] editor window is displayed, and then click another output channel, that channel group will
be displayed in the [Matrix Mixer - All Inputs to One Output] editor window.
One [Matrix Mixer - All Inputs to One Output] editor window is displayed for each matrix mixer
component editor.
■ One Input to All Outputs
When you click the input channel number on the left side of the matrix, the [Matrix Mixer - One Input
to All Outputs] editor window opens. One input channel and the send levels from the input channel
to all output buses are displayed. The input channel is the one you have clicked on in the delay
mixer component editor.
Section Parameter Setting Range Function
1 Input Channel -- Displays the selected input channel. Select
another channel from a menu.
2 Phase ON/OFF Reverses the phase of the input signal.
3
Level -
∞ to +10 dB
Sets the input signal level.
4 Solo ON/OFF Turns solo ON. If Solo is engaged for even
one channel, all non-Solo channels will be
muted.
5 On ON/OFF Turns input ON.
6
Bus Send Level Level -
∞ to +10 dB
Sets the send level from the input channel to
each output bus.
7 On ON/OFF Turns ON the send from the input channel to
each output bus.
8 Block On -- Turns ON send to all channel buses. When
turned ON, the [On] button lights up.
9
Off -- Turns OFF send to all output buses.
) Nominal -- Resets all send levels, making them 0 dB.
! Minimum -- Resets all send levels, making them87 - ∞ dB.
8
9
!
)
1
2
4
5
3 6
7