RIDGID micro CA-300 - Manual (Page 13)

micro CA-300 Inspection Camera
11
Figure 12 - Splash Screen
Live Screen
The live screen is where you will do most of
your work. A live image of what the cam‑
era sees is displayed on the screen. You can
zoom, adjust LED brightness and take im‑
ages or video from this screen.
The screen has a status bar at the top show‑
ing the tool mode, battery status, and an
SD™ card icon if inserted, and the bottom in‑
formation bar shows information about the
Time and Date.
Figure 13 - Live Screen
Information Bar
Status Bar
When the Inspection Camera is turned ON,
the default mode is for capturing still im‑
ages.
Pressing the menu button at any time will ac‑
cess the menu. The menu will overlay on the
LIVE Screen. Use the right and left arrow
buttons to switch to the MODE category. Use
the up and down arrows to navigate be‑
tween menu items and press select as
desired.
Figure 14 - Screen Shot of Mode Selection
3. If the other inspection camera settings
(such as time stamp, image quality, lan‑
guage, Date/Time, TV out, and Storage
device) need to be adjusted, see Menu
Section.
4. Prepare the camera for inspection. The
camera cable may need to be pre‑formed
or bent to properly inspect the area. Do
not try to form bends less than 5” (13 cm)
radius. This can damage cable. If inspect‑
ing a dark space, turn the LEDs on before
inserting the camera or cable.
Do not use excessive force to insert or
withdraw the cable. This may result in
damage to the inspection camera or
inspection area. Do not use the cable
or imager head to modify surroundings,
clear pathways or clogged areas, or as
anything other than an inspection de‑
vice. This may result in damage to the
inspection camera or inspection area.
Image Adjustment
Adjust LED Brightness: Pressing the right
and left arrow button on the button pad
(In live screen) will increase or decrease the
LED brightness. A brightness indicator bar
will be displayed on the screen as you adjust
brightness.