1 using serial console – SENA LS110 User Manual
Page 15
Advertising
15
2.3.1 Using Serial Console
1) Connect the one end of the serial console cable to the serial port of the LS110.
Figure 2-5 Connecting a serial console cable to the LS110
2) Connect the other end of the cable to the serial port of user’s computer.
3) Slide Data/Console switch to Console side.
Figure 2-6 Data/Console switch of the LS110
4) Run a terminal emulator program such as HyperTerminal. Set up the serial configuration
parameters of the terminal emulation program as follows:
Baud rate : 9600 / Data bits : 8 / Parity : None / Stop bits : 1 / No flow control
5) Type the user name and password to log into the LS110.
A factory default setting of the user
name and password are both ‘root’
Advertising