SENA LS110 - Manual (Page 57)

57
7: Other Menus
7.1 Save Changes
With ‘Save changes’ menu, current parameter changes are saved to non-volatile memory. Usage of
‘Save changes’ is as follows
-----------------------------------------------------------------------------
Welcome to LS110 Configuration Page
Serial No. :
MAC Address : 00:01:95:AF:BD:44
F/W REV. : v0.4.8
IP Mode : Static IP IP Address : 192.168.161.5
-----------------------------------------------------------------------------
Console#1 (Serial) : Connected
Console#2 (Telnet) : Available
Console#3 (Telnet) : Available
-----------------------------------------------------------------------------
1. IP configuration
2. Serial port configuration
3. System information
4. System administration
5. Save changes
6. Exit without reboot
7. Save and reboot
<ESC> Back, <ENTER> Refresh
---> 5
Modifications are saved.
Figure 7-1 Save changes
Saved changes will be applied if the LS110 is rebooted by ‘reboot’ command or manual rebooting.
7.2 Exit Without Reboot
With ‘Exit without reboot’ menu, current serial or remote console session will be closed. However, if
any of the settings are changed, they will not be applied until the LS110 is manually rebooted. Usage
of ‘Exit without reboot’ is as follows.
-----------------------------------------------------------------------------
Welcome to LS110 Configuration Page
Serial No. :
MAC Address : 00:01:95:AF:BD:44
F/W REV. : v0.4.8
IP Mode : Static IP IP Address : 192.168.161.5
-----------------------------------------------------------------------------
Console#1 (Serial) : Connected
Console#2 (Telnet) : Available
Console#3 (Telnet) : Available
-----------------------------------------------------------------------------
1. IP configuration
2. Serial port configuration
3. System information
4. System administration