SENA LS110 - Manual (Page 40)

40
4.2 Serial Port Configuration
To attach the serial device to the LS110 serial port, its serial settings should match exactly to that of
the serial device.
4.2.1 Baud Rate
Baud rate settings for the LS110 is as follows.
1200, 2400, 4800, 9600, 19200, 38400, 57600 and 115200
The baud rate can be changed by ‘Baud rate’ menu of ‘Serial port configuration’.
-------------------------------------------------------------------------------
Serial port configuration
-------------------------------------------------------------------------------
1. Baud rate : 9600
2. Data bits : 8
3. Parity : None
4. Stop bit(s) : 1
5. Flow control : Hardware
6. Inter-character timeout : 0
7. Host mode : TCP Client
8. Destination IP : 192.168.23.30
9. Destination port : 7001
10. Inactivity timeout : 0
11. Cyclic connection : 0
12. DTR behavior : Always HIGH
13. DSR behavior : None
14. Allowed IP : 0.0.0.0
15. Allowed subnet : 0.0.0.0
<ESC> Back, <ENTER> Refresh
---> 1
Select baud rate
1 = 1200, 2 = 2400, 3 = 4800, 4 = 9600
5 = 19200, 6 = 38400, 7 = 57600, 8 = 115200
--->
Figure 4-8 Set up the baud rate