SENA LS110 - Manual (Page 38)

38
ATBn, ATCn, ATLn, ATMn,
ATNn, ATP, ATT, ATYn,
AT%Cn, AT%En, AT&Bn,
AT&Gn, AT&In, AT&Qn,
AT&V, ATMn, AT\An,
AT\Bn, AT\Nn, ATXn
None OK [CR][LF]
ATSn?, ATSn=x
Internal S-register can be set or read.
Default values are shown on Table 4-5
Changed values are not preserved if th power is off.
<=
AT&Cn, AT&Wn, AT&Zn=x response is ERROR. ERROR [CR][LF]
ATFn [CR][LF] None
If n=1
OK [CR][LF]
If others,
ERROR [CR][LF]
ATWn None
If n=0
OK [CR][LF]
If others,
ERROR [CR][LF]
Table 4-4 AT commands Response Code
Verbose Code
(After “ATV1” command executed)
Numeric Code
(After “ATV0” command executed)
Description
OK 0 Command executed
CONNECT 1 Modem connected to line
RING 2 A ring signal has been detected
NO CARRIER 3 Modem lost carrier signal
ERROR 4 Invalid command
Table 4-5 Default value of S-Registers
Index Default Value Index Default Value Index Default Value
0 ~1 0 2 43 3 13
4 10 5 8 6 2
7 30 8 2 9 6
10 14 11 100 12 50