SENA LS110 - Manual (Page 16)

16
6) If the user logged into the LS110 successfully, a menu selection screen will appear on the
computer as shown in Figure 2-7.
LS110 login : root
password : *****
-------------------------------------------------------------------------------
Welcome to LS110 Configuration Page
Serial No. :
MAC Address : 00:01:95:AF:BD:44
F/W REV. : v0.4.8
IP Mode : Static IP IP Address : 192.168.23.12
-------------------------------------------------------------------------------
Console#1 (Serial) : Connected
Console#2 (Telnet) : Available
Console#3 (Telnet) : Available
-------------------------------------------------------------------------------
1. IP configuration
2. Serial port configuration
3. System information
4. System administration
5. Save changes
6. Exit without reboot
7. Save and reboot
<ESC> Back, <ENTER> Refresh
--->
Figure 2-7 The LS110 console screen
At menu selection screen, user can select each menu, by choosing the appropriate number.
Using menu number 5, you can save changes. Menu number 6, you can exit the console without
rebooting the device. Selecting option number 7, user can save changes and reboot system
simultaneously, after the reboot the reflected changes will be set to LS110.
2.3.2 Using Remote Console
The LS110 provides remote console feature via telnet as well as serial console so that users can
access the LS110 at remote site for configuration and monitoring. The IP address of the LS110 must
be known before users can access the remote console port. The port number for the remote console is
23, which is a TCP port number assigned for Telnet.
Up to three user can log into the LS110 at the same time.(Maximum Two users in Remote console and
one user in Serial console)
To access remote console of the LS110, please use the step as follows:
1) Run a telnet program or a program that supports telnet functions such as TeraTerm-Pro or
HyperTerminal. The target IP address and the port number should be those of the LS110. If
required, specify the port number as 23.
Type the following command in the command line interface of your computer.