SENA LS110 - Manual (Page 52)

52
6.4 Factory Reset
With ‘Factory reset’ menu, users can load factory default parameter values in console. Usage of
‘Factory reset’ is as follows:
-------------------------------------------------------------------------------
System administration
-------------------------------------------------------------------------------
1. Device name : LS110
2. Username : root
3. Password : root
4. Factory reset
5. Factory reset without IP settings
6. Firmware upgrade
7. Ping
8. User connection status
9. Telnet configuration enable/disable : Enable
<ESC> Back, <ENTER> Refresh
---> 4
Factory Reset started....
LS110 login :
Figure 6-5 Factory reset Screen
6.5 Factory Reset Without IP Settings
With ‘Factory reset without IP settings’ menu, users can load factory default parameter values without
changing IP related settings such as IP mode / IP address / Subnet mask / Default gateway. These
parameters’ values are not affected by this menu.
Usage of ‘Factory reset without IP settings’ is as follows:
-------------------------------------------------------------------------------
System administration
-------------------------------------------------------------------------------
1. Device name : LS110
2. Username : root
3. Password : root
4. Factory reset
5. Factory reset without IP settings
6. Firmware upgrade
7. Ping
8. User connection status
9. Telnet configuration enable/disable : Enable
<ESC> Back, <ENTER> Refresh
---> 5
Factory default without IP setting started...
LS110 login :
Figure 6-6 Factory reset without IP settings Screen