SENA LS110 - Manual (Page 55)

55
Type ‘ping’ on the keyboard and press Enter. Then type IP address to send ping on the keyboard.
6.8 User Connection Status
‘User connection status’ menu, allows you to see how many users are logged into the LS110. LS110
allows maximum two users in remote console and one user in serial console. Usage of ‘User
connection status’ is as follows.
-----------------------------------------------------------------------------
System administration
-----------------------------------------------------------------------------
1. Device name : LS110
2. Username : root
3. Password : root
4. Factory reset
5. Factory reset without IP settings
6. Firmware upgrade
7. Ping
8. User connection status
9. Telnet configuration enable/disable : Enable
<ESC> Back, <ENTER> Refresh
---> 8
-----------------------------------------------------------------------------
User connection status
-----------------------------------------------------------------------------
Console#1 (Serial) : Connected
Console#2 (Telnet) : Available
Console#3 (Telnet) : Available
-----------------------------------------------------------------------------
End of user connection status.
Figure 6-12 User connection status screen
6.9 Telnet Configuration Enable/Disable
Using ‘Telnet configuration enable/disable’ menu, LS100 can control the connectivity of Remote
Console to the LS110.
-----------------------------------------------------------------------------
System administration
-----------------------------------------------------------------------------
1. Device name : LS110
2. Username : root
3. Password : root
4. Factory reset
5. Factory reset without IP settings
6. Firmware upgrade
7. Ping
8. User connection status
9. Telnet configuration enable/disable : Enable
<ESC> Back, <ENTER> Refresh
---> 9
Select telnet configuration Enable/Disable (1 = Enable, 2 = Disable)
--->
Figure 6-13.setting ‘Telnet configuration enable/disable’