GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 12)

A Series ® Lighting Controller Programmer
Chapter 5 – Schedules Menu
8
The Schedules menu is used to control and configure the
16 lighting schedules, ZN01 SCH to ZN16 SCH. These
schedules can be operated in manual or auto mode;
manual mode has highest priority. The Schedules menu is
used to add, edit, and delete
On and Off times, and to add
calendar references. One calendar reference can be added
to any one schedule.
Navigating the Schedules Menu
The Schedules menu and the special functions of several
of the keys are illustrated in Figure 5. The following items
relate to setting schedules:
• Use the arrow keys to scroll directly to a specific
day of the week, an existing CAL reference, or to
Add CAL.
• If no adjustments are made to a specific day of the
week, pressing 3 moves to the next day of the
week.
• Press the number 2 key at any point to go back to
a previous selection.
• On/Off times are not accepted into the schedule
unless they are modified. To keep a displayed
time the same, adjust it using the arrow keys up
one minute, back down one minute, and then
press 3 to accept the change.
• Schedules that contain more that one set of
On/Off time blocks in a single day cannot
overlap. However, the time blocks can be
scheduled side by side.
For example, one set of time blocks can start at
8:00
A . M . and stop at 4:00 P . M . The next set time
blocks can start at 4:01 P . M . and stop at 5:30 P . M .
Manually Adjusting a Schedule
Any of the 16 schedules, ZN01 SCH to ZN16 SCH, can be
manually turned on and off independent of the time and
day setting of the schedule. Do the following to manually
operate the schedule:
1. Navigate to the Schedules menu and press OK .
2. Use the arrow keys to view all schedules and press OK
to select a specific schedule.
3. Press the A/M key to change to manual mode.
Figure 5. Schedules menu and special key functions.
Arrow keys scroll
through the days
of the week.
Hold the OK key in
whle pressing the Up
arrow to adjust the
time.
Press the 2 key to
return to a previous
selection.
Press the 3 key to
enter and edit On/Off
times and to accept
schedule changes.
Flashing
Flashing