GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 5)

A Series ® Lighting Controller LCD Programmer
Chapter 1 – Navigating the Keypad and Display
1
Programmer Layout
The key features of the Programmer are illustrated in
Figure 1.
Figure 1. Key features of programmer keypad and display.
Navigating the Programmer
Menus
The top four keys of the LCD keypad are used to
navigate the controller menus, as follows:
• Press the OK key to enter the desired
programmer menus, accept selections, or make
value changes.
• Press the up or down arrow keys to navigate
through the main menus or submenus. The
down arrow scrolls from the first item to the
last and then rolls over to the beginning when
all menus have been viewed. The up arrow
does the opposite, scrolling back from the last
menu item to the first.
• Press the ESC key to go back to a previous
menu or to initiate a user logoff from the main
menu.
LCD
Down arrow key moves
through menus and
decreases valuses.
ESC key rejects changes
and moves to previous
menu levels.
All number keys
are used for their
numeric values.
2 and 3 keys are
used within the Set
Schedule menu.
4 key is used within
the Calendar menu to
delete a date.
A/M key switches
between auto and
manual modes.
Fn key is only used
within certain menus
to access special
functions.
Up arrow key moves
through menus and
increases valuses.