Breaker test, A series – GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide User Manual
Page 24
Advertising
A Series
®
Lighting Controller Programmer
Chapter 7 – I/O Menu
20
8.
Press
E S C
as needed to return to the desired
previous menu.
Breaker Test
The breaker test is used to toggle the breaker output for
test time (test time can be adjusted in the device
submenu of the Configuration menu) and then
relinquish the breaker.
To edit Breaker Test, use the following procedure:
1.
Navigate to the Breaker test menu and press
OK
.
2.
Press the
A/M
key to change to manual mode:
3.
Press the arrow keys to change from off to on or
vice versa:
4.
Press OK to accept changes and switch to auto
mode:
Flashing
Flashing
Flashing
Advertising