GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 48)

A Series ® Lighting Controller Programmer
Chapter 12 – Configuration Menu
44
Reset the Controller Backplane
(MP 430)
This function resets the back plane of the controller.
Note that it should only be used instant remapping of
the breaker is needed or the breaker is remapped for
diagnostic purposes.
1. From the Configuration menu, use the arrow keys
to scroll to the MSP430 RESET menu.
2. Press OK to start the edit:
3. Press the A/M key to change to manual mode:
4. Press the up arrow key to change OFF MAN to ON
MAN:
5. Press OK to reset the MSP430 and turn off the
function:
6. Press OK key twice to jump to return to auto mode:
7. Press ESC to return to the Configuration menu.
Reconfigure Network
The Reconfigure menu is used to resolve address
conflicts when installing new control equipment onto a
network. Each device uses information from its DIP
switch settings and from the other devices on the
network to determine its proper address. The
Reconfigure function changes the addresses of devices
so that they can communicate on the network.
1. From the Configuration menu, use the arrow keys
to scroll to the Reconfigure Network submenu:
2. Press OK to display the following:
3. Use the arrow keys to select Yes or No”
4. Press OK to accept the changes and start the
configuration:
5. When the reconfiguration is complete, the display
returns to the Reconfigure Network submenu.
6. Press ESC to return to the Configuration menu.
Flashing
Flashing