A series – GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide User Manual
Page 40
A Series
®
Lighting Controller Programmer
Chapter 9 – Dimming Menu
36
2.
Press the
A/M
key to switch to manual mode:
3.
Use the numeric keys to set the desired value; in
this example, from 200 to 100.
4.
Press
OK
to accept the change. Press
OK
again,
followed by the
A/M
key to return to auto mode:
5.
Press
OK
key to make the switch to auto mode:
Note that unless you are familiar with the feedback
loop, it is advisable to not change the default
value.
6.
Press down arrow key to go to the LTG RR object.
Setting Lighting Feedback Loop Rest Rate
1.
Scroll to the LTG RR object; the display will be
similar to the following:
2.
Press
OK
to edit the settings:
3.
Press the
A/M
key to switch to mode.
4.
Press the numeric keys to set the desired value; in
this example, from 4 to 30:
5.
Press
OK
to accept the change.
6.
Press
OK
again, followed by the
A/M
key to return
to auto mode:
7.
Press
OK
to make the switch to auto mode.
Note that unless you are familiar with the feedback
loop, it is advisable to not change the setting of the RR
object.
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing