GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 47)

A Series ® Lighting Controller LCD Programmer
Chapter 12 – Configuration Menu
43
increments of 0.5 hours from a maximum +12.0 to
a minimum –12.0 hours. The value flashes on the
LCD screen until accepted:
5. Press OK to accept the changes and return to the
Set UTC submenu.
6. Press ESC to return to the Device menu.
Setting the Breaker Test Time
The Breaker Test time submenu is used to set the
breaker test time in conjunction with the Breaker Test
function in the I/O menu.
1. From the Device menu, press the arrow keys to
scroll to the Breaker Test Time submenu:
2. Press OK to edit the test time:
3. Press the A/M key to switch the object to manual
mode:
4. Use the numeric keys to change the test time (in
seconds) to the desired value and press
OK to
accept the change.
5. Press ESC to return to the Device menu.
Setting the Password
The Set Password function is used to change the four-
digit numeric password for logging in to the network.
1. From the Device menu, press the arrow keys to
scroll to the Set Password submenu:
2. Press OK to enter a new password:
3. Enter a four-digit password with the numeric
keypad:
4. When Confirm PW is displayed, re-enter the
password:
5. One of the following occurs:
• If the two numbers entered are the same, then
PW Reset is displayed, indicating that the
change has been accepted. Go to step 6.
• If the passwords do not match, Reset Fail is
displayed on the LCD screen. Press ESC or OK
and repeat the sequence for setting the
password.
6. Press OK or ESC to return to the Set Password
submenu.
7. Press ESC to return to the Device menu.
Flashing
Flashing
Flashing